2011

■ Step 2: Setting Cleanup Options (page 771)
■ Overview of Cleanup Actions (page 788)
■ Erase Dangling Objects (page 809)
■ Break Crossing Objects (page 797)
NOTE This procedure is for drawing objects only. There is no equivalent for
geospatial feature data.
To extend undershoots
1 Click Tools tab ➤ Map Edit panel ➤ Clean Up.
2 On the Select Actions page, in the Cleanup Actions list, click Extend
Undershoots. Click Add.
3 In the Select Actions list, click Extend Undershoots to display the cleanup
parameters for this action.
4 Under Cleanup Parameters, set Tolerance to a value slightly larger than
the largest gap.
You can enter a value into the Tolerance box or click Pick to go to the
map and select two points that define the tolerance to use.
5 To break target linear objects at the intersections during the Extend
Undershoots operation, select Break Target.
6 Continue specifying Drawing Cleanup settings.
NOTE Using the Extend Undershoots option on an arc whose endpoints are very
close may result in the duplication or extension of the arc.
Quick Reference
MAPCLEAN
Performs drawing cleanup operations
Modify menu ➤ Drawing Cleanup
Menu
Cleaning Up Drawing Data | 801