2011

4 In the Drawing Cleanup (page 1591) dialog box, follow these steps:
■ Selecting and Anchoring Objects (page 770). Select the objects to
include in the cleanup operation and the objects to anchor. Click
Next.
■ Setting Cleanup Options (page 773). Select cleanup actions and set the
parameters for each action you select. Specify whether to correct errors
automatically or to review and confirm each correction. Click Next.
■ Converting Objects After Cleanup (page 776). Specify how to treat the
original objects after the cleanup operation is complete. Click Next.
■
Setting Markers for Interactive Mode (page 777). If you selected
Interactive mode in Setting Cleanup Options to review error
corrections, specify the error markers to use. Click Next.
■ Saving Cleanup Settings (page 781). To save your settings as a profile,
click Save.
5 Click Finish.
AutoCAD Map 3D performs the cleanup with the options and values you
specified.
6 Depending on whether you selected Interactive or Automatic, AutoCAD
Map 3D does one of the following:
■ If you selected Interactive mode (page 783), AutoCAD Map 3D displays
a list of detected errors. You can review the errors and decide how to
handle them. For example, you can place markers on the errors, correct
them, or ignore them.
■ If you selected
Automatic mode (page 782), AutoCAD Map 3D corrects
all detected errors automatically and reports a summary of the results
on the command line.
You can run the operation again to verify that you corrected all existing errors.
Cleaning up geometry in a drawing creates new geometry and new
relationships between the objects. You may need to repeat the cleanup
operation.
Quick Reference
MAPCLEAN
768 | Chapter 6 Creating and Editing Data