2011

Table Of Contents
6 In the Image Insertion dialog box specify where to insert the image. You
can enter X,Y coordinates for the image, or manually specify the insertion
point in the drawing. Each option is described below.
To insert the image manually
1 In the Image Insertion dialog box, on the Insertion tab, click Pick.
2 Pick the base point for the frame.
You can also type coordinates at the command prompt.
3 Type a rotation angle or pick a point to define the rotation angle.
Rotation is in degrees or in the units set by the AUNITS variable. The
image is rotated around the insertion point.
4 Pick the second corner point to define the size of the frame.
The Image Insertion dialog box displays the new coordinates, rotation,
and scale.
5 Click OK to insert the image into the specified frame.
To enter the coordinates for the image insertion point
1 Specify the insertion point for the lower-left corner of the image frame.
The insertion point values on the Source tab use the unit specified at the
bottom of the Source tab. The insertion point values on the Insertion tab
are translated to the current AutoCAD Map 3D drawing unit.
2 Specify the rotation.
Use current drawing angle units. This value uses the lower-left corner as
the base point.
3 Specify the scale.
If the image you insert contains correlation information, the image is
inserted at the scale specified by that information. Otherwise, the image
is inserted at a scale factor of 1 image unit of measurement to 1 AutoCAD
Map 3D unit of measurement.
A scale factor greater than 1 enlarges the image, while a scale factor less
than 1 makes the image smaller. For example, to make the image twice
as large, type 2 in the Scale box.
You can change the scale to align the image with the vector geometry in
the drawing. For example, if your raster image has a scale of 1 inch equals
452 | Chapter 3 Bringing In Data