2011

NOTE There is a shortcut for adding an activity and automatically binding
it to the previous activity. Right-click an activity and click the activity to add.
For example, right-click an Overlay activity and click Add Feature Layer to
create a new Display Manager layer that stores the output of the Overlay
operation.
7 Optionally, do any of the following:
■ To add another activity, drag it from the Activities panel to the desired
position in the workflow diagram, or right-click the activity that
precedes the new one.
When you right-click, the list contains activities that would logically
follow the current one. When you add an activity in this way, you
can automatically bind it to the one you right-clicked. For example,
right-click an Overlay activity and click Add Feature Layer to create a
new Display Manager layer that stores the output of the Overlay
operation.
■ To delete an activity, click
on its box.
■ To turn the run-time prompt for an activity on or off, click on its
box.
When the run-time prompt is on, anyone running this workflow must
provide the input for this activity. For example, the person running
the workflow must provide data store connection information for a
Connect To Data Store activity.
■ To disable or enable the activity, click
on its box.
Disable an activity temporarily to resolve problems with a workflow.
If you are not sure which activity is causing the problem, disable them
one at a time when you run the workflow. This can isolate the issue.
■ Undo or redo any changes during this editing session using
8 Save any changes to the workflow by clicking at the top of the
Workflow Designer window.
To save your changes as a new workflow, click instead.
Workflows saved in AutoCAD Map 3D 2011 format cannot be opened
in AutoCAD Map 3D 2010. To use your workflow with AutoCAD Map
3D 2010, make sure that the workflow contains only activities that were
286 | Chapter 2 Setting Up