2011

Click Map Setup tab ➤ Topology panel ➤ Rename. Specify a name
without an asterisk.
Permanent
Objects are retrieved into the current drawing, and a new topology is created.
Topology Selection dialog box
NOTE This functionality applies only to drawing objects.
Use this dialog box to select a topology.
To load a topology (page 907)
To unload a topology (page 908)
To audit, recreate, or complete a topology (page 920)
To delete a topology (page 926)
Click Analyze tab ➤ Drawing Object panel ➤ Load Topology.
Click a topology and click OK.
If the topology you want is not listed, check the following:
■ If you are selecting a topology to rename, unload, view statistics, audit,
etc., it may not be listed because it has not been loaded yet.
■ If you are selecting a topology to load, it may not be listed because it's
already loaded.
Topology Statistics dialog box
NOTE This functionality applies only to drawing objects.
Use this dialog box to view information about the selected topology.
To view topology statistics (page 916)
Topology Selection dialog box | 2011