2011

Point Object for Node Creation
Specify the block used to represent nodes.
■ To create nodes using a block defined in the drawing set, click the down
arrow and select a block from the list.
■ To create nodes using a block saved as a DWG file, click Browse. Select
the file to use. This inserts the entire DWG as a single block.
■ To create nodes as a point, select ACAD_POINT.
Load
Use settings that you previously saved.
Save
Save the current settings so you can use them again.
Cancel
Close the dialog box without performing the topology overlay.
Back
Display the previous dialog box.
Next
Disabled because this is the last dialog box in the list.
Finish
Perform the topology overlay using the current settings. The Finish is
available after you select the overlay topology and enter a valid topology
name for the resulting topology.
Topology Overlay Analysis - Output Topology dialog box
NOTE This functionality applies only to drawing objects. To do an overlay analysis
for geospatial feature data, see
Overlaying Two Feature Sources (page 1309).
Use this dialog box to specify settings for viewing the resulting overlay topology
onscreen.
To find sliver polygons when overlaying two topologies (page 843)
2004 | Chapter 38 Topology Dialog Boxes