2011

Load
Use settings that you previously saved.
Save
Save the current settings so you can use them again.
Cancel
Close the dialog box without performing the topology overlay.
Back
Display the previous dialog box.
Next
Disabled because this is the last dialog box in the list.
Finish
Perform the topology overlay using the current settings. The Finish is
available after you select the overlay topology and enter a valid topology
name for the resulting topology.
Topology Overlay Analysis - Create Nodes dialog box
NOTE This functionality applies only to drawing objects. To do an overlay analysis
for geospatial feature data, see
Overlaying Two Feature Sources (page 1309).
Use this dialog box to specify whether or not to create new nodes at the
endpoints of links where they are missing in the resulting overlay topology.
If so, you specify the block to use to create the nodes.
To find sliver polygons when overlaying two topologies (page 843)
Click Analyze tab ➤ Drawing Object panel ➤ Object Overlay.
Create New Nodes For Topology
Select this check box to create new nodes as needed at the endpoints of
links in the resulting topology. This is optional, but can be useful if you are
going to analyze the resulting topology later on.
Topology Overlay Analysis - Create Nodes dialog box | 2003