2011

Finish
Dissolves the topology using the current settings. The Finish is available
after you specify the dissolve parameter and enter a valid topology name.
Topology Dissolve - Create Nodes dialog box
NOTE This functionality applies only to drawing objects.
Use this dialog box to specify whether or not to create new nodes at the
endpoints of links where they are missing in the resulting dissolve topology.
If so, you specify the block to use to create the nodes.
To dissolve a composite topology (page 1343)
Click Analyze tab ➤ Drawing Object panel ➤ Dissolve.
Create New Nodes For Topology
Select this check box to create new nodes as needed at the endpoints of
links in the resulting topology. This is optional, but can be useful if you are
going to analyze the resulting topology later on.
Point Object for Node Creation
Specify the block used to represent nodes.
■ To create nodes using a block defined in the drawing set, click the down
arrow and select a block from the list.
■ To create nodes using a block saved as a DWG file, click Browse. Select
the file to use. This inserts the entire DWG as a single block.
■ To create nodes as a point, select ACAD_POINT.
Cancel
Close the dialog box without performing the dissolve.
Back
Display the previous dialog box.
Next
Disabled because this is the last dialog box in the list.
Topology Dissolve - Create Nodes dialog box | 1995