2011

To select from a list of layers, click Layers.
Block Filters box
Specify which blocks to search for objects to be used for the topology.
■ To search all blocks, enter an asterisk (*).
■ To select from a list of block definitions in the drawing set, click Blocks.
■ To select point objects, enter ACAD_POINT.
Rename Topology dialog box
NOTE This functionality applies only to drawing objects.
Use this dialog box to rename a topology.
To change the name, description, or both of a topology (page 925)
Click Map Setup tab ➤ Topology panel ➤ Rename.
Before you rename a topology, check the following:
■ Attach all source drawings that are referenced by the topology. If the source
drawings are not attached, you could corrupt your data set.
■ Make sure the topology is loaded. The topology needs to be completely
represented, either in source files or in the current drawing.
■ You cannot rename a topology if there are any queried objects in the
current drawing. You must save all queried objects back to their source
drawings or detach them from their source drawings before you can rename
any topology.
■ Be sure the Create Backup File Of Source Drawing option is not selected
on the Save Back tab of the
AutoCAD Map Options dialog box (page 1908).
■ You cannot undo this rename operation using the UNDO command.
1988 | Chapter 38 Topology Dialog Boxes