2011

■ Link Reverse Resistance — Specify the resistance in the opposite direction
along a link. If you leave the box blank, the length of the line (.LENGTH)
is used.
■ Node Resistance — Specify the resistance to cross the node, for example,
resistance for a valve in a pipe network, or a junction in a road network.
If you leave the box blank, zero (0) is used.
■ Specify a minimum and maximum resistance for the trace.
TIP The best route cannot be be calculated if the network topology contains
negative resistance values or if all resistance values equal zero (or use expressions
that evaluate to zero). If all resistance values equal zero, every route is as good
as another, and there is no "best route."
Load
Use settings that you previously saved.
Save
Save the current settings so you can use them again.
Cancel
Close the dialog box without performing the network analysis.
Back
Display the previous dialog box.
Next
Click to display the
Network Topology Analysis - Output dialog box (page
1980).
Finish
Perform the network analysis using the current settings.
Network Topology Analysis - Select Method dialog box
NOTE This functionality applies only to drawing objects.
Use this dialog box to specify the type of network analysis to perform.
To perform a shortest path trace (page 1326)
To perform a best route analysis (page 1330)
To perform a flood trace (page 1334)
Network Topology Analysis - Select Method dialog box | 1983