2011

Load Topology From Source Drawing dialog box
NOTE This functionality applies only to drawing objects.
Use this dialog to set options when loading a topology from a source drawing.
To load a topology (page 907)
Click Analyze tab ➤ Drawing Object panel ➤ Load Topology.
Topology Objects
Create Topology Objects When Loaded
If the selected topology is from a source drawing, select this check box to
copy the topology objects into the current drawing as the topology is loaded.
If this option is not selected, the objects are loaded but are not copied into
the current drawing.
Select Topology Objects For Save Back
Select this option to add objects in the current drawing to the save back set
if they are referenced by the selected topology. This means that the objects
will be saved back to their source drawings and replace the original objects.
Topology Verification
Audit Geometry of Topology Objects
Select this option to verify that objects for the selected topology are
geometrically correct. Any objects that are not correct are highlighted.
Network Topology Analysis - Choose Locations dialog box
NOTE This functionality applies only to drawing objects.
Use this dialog box to specify the locations to use for your network analysis.
To perform a shortest path trace (page 1326)
To perform a best route analysis (page 1330)
To perform a flood trace (page 1334)
1978 | Chapter 38 Topology Dialog Boxes