2011

Enter new reverse resistance <1.000>:
Enter a new value.
MAPLINKADD (Add Topology Link command)
NOTE This functionality applies only to drawing objects.
WARNING This command will not be supported in future releases. This is the
old command for adding a link to a topology. The new command is MAPAL.
Use this command to add a link to an existing network or polygon topology
while maintaining the integrity of the topology information.
To create a link and add it to a topology (page 880)
MAPAL
Respond to the prompts:
Enter topology name (? for list) <toponame>:
Enter the name of the topology to add the link to. To display a list of all
loaded topologies, enter ?.
Enter first point:
Enter the coordinates for the first point of the line, or select the point.
Arc/Close/Halfwidth/Length/Undo/Width/<Endpoint of line>:
For information about this prompt, see the PLINE command in the AutoCAD
help.
You can use MAPLINKADD to add a link in three ways:
■ In space (connecting no existing nodes). Two new nodes are created at the
link endpoints in space.
■ From one existing node to a point in space. A new node is created at the
end point in space.
■ From one existing node to another existing node.
MAPLINKADD (Add Topology Link command) | 1941