2011

Image Detach Preferences
Ask Before Detach
Have AutoCAD Map 3D prompt you to detach an image if there are no
more frames in the drawing that reference the image.
Always Detach
Automatically detach an image when you erase the image frames.
Never Detach
Keep the image attached, even if you erase the frames.
Shift + Left Click
Shift + Left Click Image Select
Enable selection of images by placing your cursor over them and clicking
the left mouse button while pressing Shift. This feature is useful when you
are zoomed in to the image and cannot see the image frame.
Image Defaults
Use the Image Defaults tab to set correlation defaults. Most images have
correlation data that is stored in the image file header, or in a resource file,
World file, or tab file. However, some images may not have any correlation
data. For those cases, you can specify default correlation data. In addition, if
the correlation source does not include information on the scale or the density,
AutoCAD Map 3D uses the default values on this tab when inserting the image.
TIP Setting the correlation defaults can save you time if you have multiple images
that require the same insertion point, scale, rotation, and density.
Insertion Values
X
Enter the default AutoCAD Map 3D X coordinate to define the lower-left
corner of images.
Y
Enter the default AutoCAD Map 3D Y coordinate to define the lower-left
corner of images.
Z
Enter the default AutoCAD Map 3D Z coordinate to define the lower-left
corner of images.
Rotation
Enter a default rotation for images.
Raster Extension Options dialog box | 1881