2011

Correlation Source list
Select a correlation source for the image. If a resource or world file exists
for the image, it is in this list.
Insertion Point area
View the insertion point (X, Y, and Z coordinates) for the lower-left corner
of the image frame. On the Source tab, this information is in the units
specified in the Units area at the bottom of the tab. On the Insertion tab,
this information is in current drawing units.
Rotation box
Enter the amount of rotation in current drawing angle units for the image.
This value uses the lower-left corner as the base point.
Scale box
Enter a scale factor for the image. A scale factor greater than 1 enlarges the
image. For example, to make the image twice as large, enter 2.
Density box
Enter the dots (or pixels) per unit for the image.
Units list
Select the units for the insertion point and density. For example, if your
image was scanned at 300 dpi, select Inches.
Apply
Apply your changes.
Pick
Click Pick (on the Insertion tab) to draw a frame for the image. For more
information, see
To adjust the image frame manually during insertion (page
465).
Frame Color box
View the current color for the image frame and for the foreground of a
bitonal image. Usually, this is the current AutoCAD Map 3D color. However,
when you insert a bitonal image, AutoCAD Map 3D first looks for the
foreground color in the image header file or in a resource file. If it cannot
find the color information, then the foreground color defaults to the current
AutoCAD Map 3D color. To change the color, click Select (on the Insertion
tab).
1874 | Chapter 34 Raster Image Dialog Boxes