2011

Skip Topology Objects
Protect topology data. Objects with topology data are not broken.
Retain Object Data
Save object data from the original object. The data is duplicated on each
new piece.
COGO Input dialog box
The COGO Input dialog box allows you to create points using coordinate
geometry data. It also allows you to run an inverse report to determine the
relationship between two points.
To create a point using the COGO Input dialog box (page 1028)
Click Create tab ➤ Drawing Object panel ➤ COGO Input.
Routines
Select the COGO routine to use:
■ Angle/Distance: specify a point by specifying an angle and a distance
from another point.
■ Azimuth/Distance: specify a point by specifying azimuth and distance
from another point. Azimuth is the clockwise angle from the North(or
South) meridian.
■ Bearing/Bearing: specify a point using the projections from two existing
lines or points and two bearings.
■ Bearing/Distance: specify a point by specifying a bearing and a distance
from another point.
■ Deflection/Distance: specify a point by specifying a deflection angle and
a distance from another point.
■ Distance/Distance: calculated a new point using two points and two
distances to the new point. You must select one of the two calculated
points.
1668 | Chapter 23 Editing Maps Dialog Boxes