2011

Width
Linear objects that contain three-dimensional information cannot have a
width.
See also:
■ Registering the Map (page 133)
■ Configuring the Digitizer (page 131)
■ Digitizing Objects (page 1073)
■ Overview of Digitizing Maps (page 1073)
To set digitizing specifications
1 At the command prompt, enter mapdigisetup.
2 In the
Digitize Setup dialog box (page 1617), select an object type.
Select Nodes to digitize points or blocks. Select Linear to digitize polylines.
3 To attach data to objects as you digitize them, select Attach Data.
Click Data To Attach and select the table to use for the data. As you
digitize the objects, you are prompted for the data to attach to the object.
4 To change the label point for objects as you digitize them, select Prompt
For Label Point.
5 Specify the layer for new objects.
6 Specify the block (for nodes) or the linetype (for linear objects) to use
when creating the new objects.
7 Specify whether to snap to the closest endpoint (for nodes) or insertion
point (for linear objects).
8 For nodes, select whether to specify the rotation and scale of each node
block.
For linear objects, select whether the objects are 2D or 3D. For 2D objects,
specify a width.
9 Click OK to close the dialog box and save your settings.
138 | Chapter 2 Setting Up