2011

Tolerance
Specify the radial search distance for locating geometric errors. Enter a value
or click Pick to specify a distance in the drawing area.
For example, if you set the tolerance to 5 units, two nodes within 10 units
of each other are within the tolerance and will be corrected.
Rotation
Include rotation in the Delete Duplicates calculation for Blocks, Text, or
Mtext.
Z-Values
Include z-values (elevation) in the Delete Duplicates calculation.
Break Target
Break target linear objects at the intersections during the Extend Undershoots
operation.
Snap To Node
For Snap Clustered Nodes, snap to an existing node.
Snap To Link
For Snap Clustered Nodes, snap to an existing link endpoint.
Create Arcs
Allow the introduction of arcs during the Simplify Objects operation.
Weeding Distance
For Weed Polylines, enter a value or click Pick to select two locations in the
drawing. Weeding Factors reduce the number of points generated along 3D
polylines. A larger distance and deflection angle weeds a greater number of
points. The distance is measured in linear units and must be smaller than
the Supplemental Distance.
Weeding Angle
For Weed Polylines, enter the deflection angle, or click Pick to select a
starting point, a vertex, and an ending point in the drawing. A larger
distance and deflection angle weeds a greater number of points. The angle
factor is measured in angular units.
Supplemental Distance
For Weed Polylines, enter the maximum distance between vertices. If the
distance between vertices on a contour is greater, points are added along
the contour at equal intervals that are less than or equal to the Supplemental
Distance. The smaller the distance, the greater the number of supplemented
points.
1590 | Chapter 17 Cleaning Up Maps Dialog Boxes