2011

3 Enter the coordinates for the start and end points of the line, or click
to select the line on the map.
4 Enter the distance from the start point, or click
to specify the
distance on the map.
5 Repeat steps 3-4 for the second point and distance.
6 Click Calculate. AutoCAD Map 3D calculates the new point, and previews
it on your map. Click the Pan button to pan to the new point.
NOTE If you turn on the Prompt For 3D Data Input option in the Coordinate
Geometry Setup dialog box
(page 1917), you can enter an elevation value in
the Result section of the
COGO Input dialog box (page 1668).
7 Click Create Point.
Quick Reference
MAPCOGO
Specifies data for coordinate geometry calculations and reports
Click Home tab ➤ Draw panel ➤ COGO
Drop-down ➤ COGO Input.
Menu
MAPCOGOCommand Line
COGO Input dialog boxDialog Box
Creating an Inverse Report
An inverse report gives you information about the relationship between two
points. The inverse report command is only accessible from the
COGO Input
dialog box
(page 1668).
The inverse report gives you the following information about the relationship
between the two points:
■ Bearing
Creating an Inverse Report | 1045