2012

6 (Optional) If you are finished using the Block Editor, click Close Block
Editor.
To turn insertion cycling on or off for a custom grip in a dynamic block
reference
1 Click Insert tab ➤ Block panel ➤ Block Editor.
2 In the Block Editor, at the Command prompt, enter bcycleorder.
3 In the Insertion Cycling Order dialog box, select a grip from the list, and
click Cycling to turn cycling on or off for the grip. (A check mark in the
Cycling column indicates that cycling is turned on for the grip.)
4 Click OK.
5 Click Block Editor tab ➤ Open/Save panel ➤ Save Block.
6 (Optional) If you are finished using the Block Editor, click Close Block
Editor.
To modify the insertion cycling order for custom grips in a dynamic block
reference
1 Click Insert tab ➤ Block panel ➤ Block Editor.
2 In the Block Editor, enter bcycleorder at the Command prompt.
3 In the Insertion Cycling Order dialog box, select a grip from the list, and
click Move Up or Move Down. (A check mark in the Cycling column
indicates that cycling is turned on for the grip.)
4 Repeat step 2 until you are finished modifying the grip cycling order.
5 Click OK.
6 Click Block Editor tab ➤ Open/Save panel ➤ Save Block.
7 (Optional) If you are finished using the Block Editor, click Close Block
Editor.
842 | Chapter 22 Add Behaviors to Blocks (Dynamic Blocks)