2012

5 On the drop-down list, select List.
6 In the Properties palette, under Value Set, click one of the following:
■ Ang Value List
■ Dist Value List
■ Hor Value List
■ Ver Value List
7 Click the [...] button.
8 In the Add Distance Value/Angle dialog box, enter one value or two or
more values separated by commas, or to delete a value, select it from the
list.
9 Click Add or Delete.
10 Click OK.
11 Click Block Editor tab ➤ Open/Save panel ➤ Save Block.
12 (Optional) If you are finished using the Block Editor, click Close Block
Editor.
To specify an incremental value set for a linear, polar, XY, or rotation
parameter
1 Ensure that the Properties palette is displayed. If not, click Tools
menu ➤ Palettes ➤ Properties.
2 Click Insert tab ➤ Block panel ➤ Block Editor.
3 In the Block Editor, select a linear, polar, XY, or rotation parameter.
4 In the Properties palette, under Value Set, click Dist Type, Ang Type, Hor
Type, or Ver Type.
5 On the drop-down list, select Increment.
6 In the Properties palette, under Value Set, click Dist Increment, Ang
Increment, Hor Increment, or Ver Increment, and then enter an
incremental value for the parameter.
Specify Value Sets for Dynamic Blocks | 835