2012

When you chamfer an entire polyline, only the segments that are long enough
to accommodate the chamfer distance are chamfered. The polyline in the
following illustration has some segments too short to be chamfered.
To set chamfer distances
1 Click Home tab ➤ Modify panel ➤ Chamfer.
2 Enter d (Distances).
3 Enter the first chamfer distance.
4 Enter the second chamfer distance.
5 Select the lines for chamfering.
To chamfer two nonparallel line segments
1 Click Home tab ➤ Modify panel ➤ Chamfer.
2 Select the first line.
3 Select the second line.
To chamfer by specifying chamfer length and angle
1 Click Home tab ➤ Modify panel ➤ Chamfer.
2 Enter a (Angle).
3 Enter the distance from the corner to be chamfered along the first line.
4 Enter the chamfer angle.
5 Select the first line. Then select the second line.
Fillet, Chamfer, Break, or Join Objects | 697