2012

To set double-line width
1 Click Draw menu ➤ Double Line.
2 At the Command prompt, enter w (Width). Then specify a new width.
3 Specify a point to start drawing the double line.
To set the dragline for drawing double lines
1 Click Draw menu ➤ Double Line.
2 At the Command prompt, enter d (Dragline).
3 Specify the offset of the double lines from the points you specify. Enter
L (Left), c (Center), or r (Right). If you want to offset the placement point
a specific distance from the center line, enter a distance.
4 Specify a point to continue drawing the double line.
To set the endcaps for double lines
1 Click Draw menu ➤ Double Line.
2 At the Command prompt, enter ca (Caps).
3 Enter one of the following options:
■ To close both ends of the double line, enter b (Both).
■ To close only the endpoint, enter e (Endpoint).
■ To close only the start point, enter s (Start Point).
■ To leave both ends open, enter n (None).
■ To automatically close all the ends that are not snapped to another
object (the default), enter a (Auto).
4 Specify a point to continue drawing the double line.
562 | Chapter 17 Create Objects