2012

5 Under Custom Paper Sizes, click Add.
6 In the Custom Paper Size wizard, Begin page, select Start from Scratch.
Click Next.
7 On the Media Bounds page, in the Units list, select either Inches or
Millimeters for paper size.
When a nondimensional raster image, such as BMP or TIFF, is plotted,
the size of the plot is specified in pixels, not inches or millimeters.
8 In the Width and Length lists, specify the paper width and length. Click
Next.
NOTE Each plotter has a maximum printable area determined by where it
grips the paper and how far the pen shuttle reaches. If you are creating a
paper size that is larger than the paper sizes offered in the Custom Paper Size
wizard, verify that the plotter is capable of plotting the new dimensions.
9 On the Printable Area page, use Top, Bottom, Left, and Right to specify
the printable area. Click Next.
10 On the Paper Size Name page, enter a name for the paper size. Click Next.
11 On the File Name page, enter a name for the PMP file.
12 On the Finish page, specify whether the paper source is Sheet-Fed or
Roll-Fed.
13 Click Print Test Page to verify the custom size.
A cross is printed that defines the paper size and a rectangle that defines
the printable area. If all four sides of the rectangle are not printed, increase
the printable area.
14 Click Finish to exit the Custom Paper Size wizard.
To add a new custom paper size starting from an existing paper size
1 Click Output tab ➤ Plot panel ➤ Plotter Manager.
2 In the Plotter Manager, double-click the plotter configuration (PC3) file
you want to edit.
3 In the Plotter Configuration Editor, Device and Document Settings tab,
double-click User-Defined Paper Sizes & Calibration to display the
calibration and paper size settings.
Select a Paper Size for a Layout | 1173