2012

Once you add a jog to a linear dimension, you can position it by using grips.
To reposition the jog, select the dimension and then select the grip. Move the
grip to another point along the dimension line. You can also adjust the height
of the jog symbol on a linear dimension on the Properties palette under Lines
& Arrows.
To add a jog to a linear dimension
1 Click Home tab ➤ Annotation panel ➤ Jog Line.
2 Select a linear dimension.
3 Specify a point on the dimension line to place the jog.
To add a jog to a linear dimension based on the midpoint of the selected
dimension line
1 Click Home tab ➤ Annotation panel ➤ Jog Line.
2 Select a linear dimension.
3 Press Enter to position the jog at the midpoint of the selected dimension
line.
To reposition a jog using grips
1 With no command active, select the linear dimension that has the jog
you want to reposition.
2 Select the grip in the middle of the jog.
The selected grip is highlighted, and the default grip mode, Stretch, is
active.
3 Drag the crosshairs along the dimension line and click to reposition the
jog.
TIP If you want to place the jog along the dimension line without changing
the position of the dimension line, turn Ortho mode on.
1138 | Chapter 28 Dimensions and Tolerances