2012

Close
Draws an arc segment from the last point specified to the starting point,
creating a closed polyline. At least two points must be specified to use this
option.
Direction
Specifies a starting direction for the arc segment.
Specify the tangent direction from the start point of arc: Specify a point (2)
Specify endpoint of arc: Specify a point (3)
Halfwidth
Specifies the width from the center of a wide polyline segment to one of its
edges.
Specify starting half-width <current>: Enter a value or press ENTER
Specify ending half-width <starting width>: Enter a value or press ENTER
The starting half-width becomes the default ending half-width. The ending
half-width becomes the uniform half-width for all subsequent segments until
you change the half-width again. The starting and ending points of wide line
segments are at the center of the line.
PLINE | 957