2012

List of Prompts
The following prompts are displayed.
Specify start point: Specify a point
Current line-width is <current>
Specify
next point on page 954 or [Arc on page 955/Close on page 959/Halfwidth
on page 959/Length on page 960/Undo on page 960/Width on page 960]: Specify
a point or enter an option
Next Point
Draws a line segment. The previous prompt is repeated.
Arc
Adds arc segments to the polyline.
Specify endpoint of arc or
[Angle/CEnter/CLose/Direction/Halfwidth/Line/Radius/Second
pt/Undo/Width]: Specify a point (2) or enter an option
NOTE For the Center option of the PLINE command, enter ce; for the Center
object snap, enter cen or center.
Endpoint of Arc
Draws an arc segment. The arc segment is tangent to the previous segment of
the polyline. The previous prompt is repeated.
Angle
Specifies the included angle of the arc segment from the start point.
Specify included angle:
PLINE | 955