2012

List of Prompts
The following prompts are displayed.
Current settings: Erase source = current Layer = current OFFSETGAPTYPE =
current
Specify
Offset Distance on page 818 or [Through on page 818/Erase on page
818/
Layer on page 819] <current>: Specify a distance, enter an option, or press Enter
Offset Distance
Creates an object at a specified distance from an existing object.
Exit Exits the OFFSET command.
Multiple Enters the Multiple offset mode, which repeats the offset operation
using the current offset distance.
Undo Reverses the previous offset.
Through
Creates an object passing through a specified point.
NOTE For best results when you offset a polyline with corners, specify the through
point near the midpoint of a line segment, not near a corner.
■ Exit on page 818
■ Multiple on page 818
■ Undo on page 818
Erase
Erases the source object after it is offset.
818 | Chapter 15 O Commands