2012

Options Panel
Undoes actions in the Text Editor ribbon contextual tab, including
changes to either text content or text formatting.
Undo
Redoes actions in the Text Editor ribbon contextual tab, including
changes to either text content or text formatting.
Redo
Displays a ruler at the top of the editor. Drag the arrows at the end
of the ruler to change the width of the mtext object. Also displays
height and column grips when column mode is active.
Ruler
You can also select tabs from the ruler. Clicking the Tab Selection
button changes tab styles from left, center, right, and decimal. Once
you make your selection, you adjust the corresponding tab in the
ruler or in the Paragraph dialog box.
Displays a list of additional text options. See
Text Editor Shortcut
Menu on page 764.
More
Close Panel
Ends the MTEXT command and closes the Text Editor ribbon con-
textual tab.
Close Text Editor
Paragraph Dialog Box
Quick Reference
See also:
■ Overview of Multiline Text
Sets indentation for paragraphs and the first lines of paragraphs.
Summary
Specifies tab stops, indents, controls paragraph alignment, paragraph spacing,
and paragraph line spacing.
NOTE Not all of the new options for paragraph and paragraph line spacing are
supported in AutoCAD LT 2007 and previous releases. See MTEXT Paragraph and
Paragraph Line Spacing in Previous Releases in the User’s Guide.
778 | Chapter 13 M Commands