2012

Leader Type Specifies a straight, spline, or no leader line.
■ Straight.
■ Spline.
■ None.
Leader Landing Changes the distance of the horizontal landing line
■ Yes.
■ No.
If you choose No at this point, then no landing line is associated with the
multileader object.
Content Type Specifies the type of content that will be used for the
multileader.
■ Block on page 744
■
Mtext on page 744
■
None on page 744
Block Specifies a block within your drawing to associate with the new
multileader.
■ Enter block name.
Mtext Specifies that multiline text is included with the multileader.
■ Enter the multiline text.
None Specifies no content type.
Maxpoints Specifies a maximum number of points for the new leader line.
■ Enter the maximum points for leader line.
■ None.
First Angle Constrains the angle of the first point in the new leader line.
■ Enter first angle constraint.
■ None.
744 | Chapter 13 M Commands