2012

■ Total area of all defined areas and objects
■ Total perimeter of all defined areas and objects
Subtract Area Subtracts a specified area from the total area. The total area
and perimeter displays at the Command prompt and in the tooltip.
Volume
Measures the volume of an object or a defined area.
Object Measures the volume of an object or defined area.
You can select 2D objects. If you select a 2D object you must specify a height
for that object.
If you define an object by specifying points, you must specify at least three
points to define a polygon. All must lie on a plane parallel to the XY plane of
the UCS. If you do not close the polygon, an area will be calculated as if a line
existed between the first and last points entered.
If you enter Arc, Length, or Undo Options for Selecting Polylines display.
Add Volume Turns on Add mode and keeps a running total of volume as you
define areas.
Subtract Volume Turns on Subtract mode and subtracts a specified volume
from the total volume.
Options for Selecting Polylines
You can select polylines when using the Distance, Area, and Volume options.
Arc Adds arc segments to the polyline.
Endpoint of Arc Draws an arc segment. The arc segment is tangent to the
previous segment of the polyline.
Angle Specifies the included angle of the arc segment from the start point.
Entering a positive number creates counterclockwise arc segments. Entering
a negative number creates clockwise arc segments.
■
Endpoint of Arc on page 955
Radius Specifies the radius of the arc segment.
Center Specifies the center of the arc segment.
■
Endpoint of Arc on page 955
■
Angle on page 955
738 | Chapter 13 M Commands