2012

You can control block insertion behavior in response to the Enter Block Name
prompt by following the listed examples.
■ Inserting Exploded Blocks: Preceding the name of the block with an asterisk
(*) explodes the block and inserts the individual parts of it. The block
definition is not added to the drawing.
■ Updating a Block Path: If you enter a block name without a path name,
INSERT searches the current drawing data for an existing block definition
by that name. You can replace an existing block definition with an external
file by entering the following at the Enter Block Name prompt:
block name=file name
■ Updating a Block Definition: If you make changes to a block file that is inserted
in your drawing and you want to change the existing block definition
without creating a new block insertion, enter the following at the Specify
Insertion Point prompt (following the Enter Block Name prompt):
block name=
If you enter = after the block name, the following prompt is displayed:
Block "current" already exists. Redefine it? [Yes/No] <No>: Enter y, enter n,
or press Enter
If you choose to redefine the block, the existing block definition is replaced
with the new block definition. The drawing is regenerated, and the new
definition is applied to all existing insertions of the block definition. Press
Esc when prompted for the insertion point if you do not want to insert a
new block into the drawing.
?—List Block Names
Lists the blocks currently defined in the drawing.
Insertion Point
Specifies a location for the block or drawing.
Scale Factor All X and Y dimensions of the block or drawing are multiplied
by the X and Y scale factors. The block or drawing is rotated by the specified
angle, using the insertion point as the center of rotation.
Corner Defines the X and Y scale factors at the same time, using the insertion
point and another point as the corners of a box. The X and Y dimensions of
the box become the X and Y scale factors. The insertion point is the first corner.
XYZ Sets X, Y, and Z scale factors.
■ X Scale Factor: Defines X, Y, and Z scale factors for the block or drawing.
-INSERT | 625