2012

While selecting objects, you can right-click at any time in the drawing area
to display a shortcut menu. You can undo the last selection or all selections,
change the selection method, change the island detection style, or preview
the hatch or fill.
Draw Boundary
Uses specified points to define the boundary of a hatch or fill.
The options that are available as you specify points are also available in PLINE.
When you complete the polyline boundary, press Enter. You can then create
additional polyline boundaries, or press Enter to twice to apply the hatch.
NOTE To enclose an area completely, use the Close option. Do not make the first
and last points coincident.
Remove Boundaries
Removes from the boundary definition any of the objects that were previously
added.
Select Objects Removes objects from the boundary definition.
Add Boundaries Adds objects to the boundary definition.
Advanced
Sets the method used to create the hatch boundary.
Boundary Set
Specifies a limited set of objects, called a boundary set, for evaluation by the
pick point of the hatch
New Creates a boundary set from the selected objects.
Everything Creates a boundary set from everything visible in the current
viewport. Selecting this option discards any current boundary set and uses
everything visible in the drawing or in the current viewport.
Retain Boundary
Creates an object that encloses each hatch object.
-HATCH | 567