2012

Summary
To extend objects, first select the boundaries. Then press Enter and select the
objects that you want to extend. To use all objects as boundaries, press Enter
at the first Select Objects prompt.
List of Prompts
The following prompts are displayed.
Current settings: Projection = current, Edge = current
Select boundary edges...
Select objects or <select all>: Select one or more objects and press Enter, or press
Enter to select all displayed objects
Select object to extend or shift-select to trim or
[
Fence/Crossing/Project/Edge/Undo]: Select objects to extend, or hold down SHIFT
and select an object to trim, or enter an option
Boundary Object Selection
Uses the selected objects to define the boundary edges to which you want to
extend an object.
Object to Extend
Specifies the objects to extend. Press Enter to end the command.
Shift-Select to Trim
Trims the selected objects to the nearest boundary rather than extending
them. This is an easy method to switch between trimming and extending.
Fence
Selects all objects that cross the selection fence. The selection fence is a series
of temporary line segments that you specify with two or more fence points.
The selection fence does not form a closed loop.
Crossing
Selects objects within and crossing a rectangular area defined by two points.
NOTE Some crossing selections of objects to be extended are ambiguous. EXTEND
resolves the selection by following along the rectangular crossing window in a
clockwise direction from the first point to the first object encountered.
Project
Specifies the projection method used when extending objects.
EXTEND | 501