2012

Press Esc to terminate the command without losing the changes that were
already specified. Use UNDO to restore the previous state of the changed
dimensions.
The prompts for the different types of dimensions are:
Linear Specify first extension line origin or [Select object] <next>: Specify an
object snap location, enter s and select a geometric object, or press Enter to skip to
the next prompt
Specify second extension line origin <next>: Specify an object snap location, or
press Enter to skip to the next dimension object, if any
Aligned Specify first extension line origin or [Select object] <next>: Specify an
object snap location, enter s and select a geometric object, or press Enter to skip to
the next prompt
Specify second extension line origin <next>: Specify an object snap location, or
press Enter to skip to the next dimension object, if any
Angular (Three Point) Specify angle vertex or [Select arc or circle] <next>:
Specify an object snap location, enter s and select an arc or a circle, or press Enter to
skip to the next prompt
Specify first angle endpoint <next>: Specify an object snap location or press Enter
to skip to the next prompt
Specify second angle endpoint <next>: Specify an object snap location or press
Enter to skip to the next dimension object, if any
Angular (Two Line) Select first line <next>: Select a line, or press Enter to skip
to the next prompt
Select second line <next>: Select another line, or press Enter to skip to the next
dimension object, if any
Diameter Select arc or circle <next>: Select an arc or a circle, or press Enter to
skip to the next dimension object, if any
Leader Specify leader association point <next>: Specify an object snap location,
or press Enter to skip to the next dimension object, if any
Ordinate Specify feature location <next>: Specify an object snap location, or press
Enter to skip to the next dimension object, if any
Radius Select arc or circle <next>: Select an arc or a circle, or press Enter to skip
to the next dimension object, if any
NOTE DIMREASSOCIATE does not change the setting of DIMLFAC in a dimension.
Use DIMOVERRIDE to clear dimension linear factors in legacy drawings.
DIMREASSOCIATE | 357