2012

Properties
Modifies properties of existing objects.
NOTE The Plotstyle option is displayed only when you are using named plot styles.
You can change several properties at a time. The Enter Property to Change
prompt is redisplayed after each option is completed.
Color Changes the color of the selected objects.
For example, to change a color to red, enter red or 1. If you enter bylayer, the
object assumes the color of the layer on which it is located. If you enter
byblock, the object inherits the color of the block of which it is a component.
■ True Color. Specifies a true color to be used for the selected object. The
integer values range from 0 to 255 seperated by commas.
■ Color Book. Specifies a color from a loaded color book to be used for the
selected object.
Elev Changes the Z-axis elevation of 2D objects.
You can change the elevation of an object only if all its points have the same
Z value.
Layer Changes the layer of the selected objects.
Ltype Changes the linetype of the selected objects.
If the new linetype is not loaded, the program tries to load it from the standard
linetype library file, acadlt.lin. If this procedure fails, use LINETYPE to load the
linetype.
Ltscale Changes the linetype scale factor of the selected objects.
Lweight Changes the lineweight of the selected objects. Lineweight values
are predefined values. If you enter a value that is not a predefined value, the
closest predefined lineweight is assigned to the selected objects.
Thickness Changes the Z-direction thickness of 2D objects.
202 | Chapter 4 C Commands