2012

way to use CHANGE is to select only lines in a selection set or select only
objects other than lines in a selection set.
Except for zero-thickness lines, the objects selected must be parallel to the
current user coordinate system (UCS).
Change Point or Values
Changes the selected objects. The result depends on the type of objects you
select.
Lines Moves the endpoints of the selected lines that are closest to the change
point to the new point, unless Ortho mode is on. If Ortho mode is on, the
selected lines are modified so that they become parallel to either the X or the
Y axis; their endpoints are not moved to the specified coordinate.
Circles Changes the circle radius. If you selected more than one circle, the
prompt is repeated for the next circle.
Text Changes text location and other properties.
Specify New Text Insertion Point Relocates the text.
Attribute Definitions Changes the text and text properties of an attribute
that is not part of a block.
Blocks Changes the location or rotation of a block.
Specifying a new location relocates the block. Pressing Enter leaves the block
in its original location.
CHANGE | 201