2012

Trim
Controls whether CHAMFER trims the selected edges to the chamfer line
endpoints.
NOTE Trim sets the TRIMMODE system variable to 1; No Trim sets TRIMMODE
to 0.
If the TRIMMODE system variable is set to 1, CHAMFER trims the intersecting
lines to the endpoints of the chamfer line. If the selected lines do not intersect,
CHAMFER extends or trims them so that they do. If TRIMMODE is set to 0,
the chamfer is created without trimming the selected lines.
Method
Controls whether CHAMFER uses two distances or a distance and an angle to
create the chamfer.
Multiple
Chamfers the edges of more than one set of objects.
Expression
Controls the chamfer distance with a mathematical expression. See Control
Geometry with the Parameters Manager for a list of operators and functions
allowed.
CHANGE
Quick Reference
See also:
■ Display and Change the Properties of Objects
Changes the properties of existing objects.
List of Prompts
The following prompts are displayed
Select objects:
Specify
change point or [Properties]: Specify a new point, or press Enter to enter
new values
Specify Objects
If you select lines and other changeable objects in the same selection set, you
get varying results depending on the object selection sequence. The easiest
200 | Chapter 4 C Commands