2012

Access Methods
Button
Ribbon: Home tab ➤ Modify panel ➤ Chamfer and Fillet drop-down
➤ Chamfer
Menu: Modify ➤ Chamfer
Toolbar: Modify
Summary
The distances and angles that you specify are applied in the order that you
select the objects.
You can chamfer lines, polylines, rays, and xlines.
List of Prompts
The following prompts are displayed.
(TRIM mode) Current chamfer Dist1 = current, Dist2 = current
Select
first line on page 198 or [Undo on page 199/Polyline on page 199/Distance
on page 199/Angle on page 199/Trim on page 200/mEthod on page 200/Multiple
on page 200]: Use an object selection method or enter an option
First Line
Specifies the first of two edges required to define a 2D chamfer.
If you select lines or polylines, their lengths adjust to accommodate the
chamfer line. You can hold down Shift while selecting the objects to override
the current chamfer distances with a value of 0.
If the selected objects are line segments of a 2D polyline, they must be adjacent
or separated by no more than one segment. If they're separated by another
polyline segment, CHAMFER deletes the segment that separates them and
replaces it with the chamfer.
Enter Surface Selection Option
Edge
198 | Chapter 4 C Commands