2012

BGRIPSET
Quick Reference
See also:
■ Specify Grips for Dynamic Blocks
Creates, deletes, or resets grips associated with a parameter.
Access Methods
Shortcut menu: Select a parameter in the block definition. Right-click in
the Block Editor drawing area. Click Grip Display, and then click an option.
Summary
Specifies the number of grips displayed for a parameter. Also resets the position
of grips for a parameter to their default location. You can only use the
BGRIPSET command in the
Block Editor on page 127.
List of Prompts
The following prompts are displayed.
Select parameter: Select a parameter in the current dynamic block definition
Enter number of grip objects for parameter or reset position
[0/1/2/4/Reposition]: Enter the number of grips to display for the parameter (the
number of grips available will vary depending on the type of parameter you selected)
or enter reposition to reposition the existing grips in the block definition to their
default locations
BHATCH
Quick Reference
See also:
■ Overview of Hatch Patterns and Fills
Fills an enclosed area or selected objects with a hatch pattern or gradient fill.
138 | Chapter 3 B Commands