2012

11Initial value:
Controls whether Default, Edit, and Command mode shortcut menus are
available in the drawing area.
The setting is stored as a bitcode using the sum of the following values:
Disables all Default, Edit, and Command mode shortcut
menus.
0
Enables Default mode shortcut menus.1
Enables Edit mode shortcut menus.2
Enables Command mode shortcut menus whenever a
command is active.
4
Enables Command mode shortcut menus only when
command options are currently available at the Command
prompt.
8
Enables the display of a shortcut menu when the right
button on the pointing device is held down long enough
16
NOTE When this system variable is set to a value greater than 15, the
SHORTCUTMENUDURATION on page 1656 system variable determines the length
of time that the right button on the pointing device must be held down to display
a shortcut menu.
SHORTCUTMENUDURATION
Quick Reference
See also:
■ Set Up the Drawing Area
IntegerType:
RegistrySaved in:
250Initial value:
Specifies how long the right button on a pointing device must be pressed to
display a shortcut menu in the drawing area.
1656 | Chapter 44 S System Variables