2012

Table Of Contents

PSLTSCALE

Quick Reference

See also:

■ Scale Linetypes in Layout Viewports

IntegerType:

DrawingSaved in:

1Initial value:

Controls the linetype scaling of objects displayed in paper space viewports.

No special linetype scaling. Linetype dash lengths are

based on the drawing units of the space (model or paper)

in which the objects were created. Scaled by the global

LTSCALE factor.

Viewport scaling governs linetype scaling. If TILEMODE is

set to 0, dash lengths are based on paper space drawing

units, even for objects in model space. In this mode,

viewports can have varying magnifications, yet display

linetypes identically. For a specific linetype, the dash

lengths of a line in a viewport are the same as the dash

lengths of a line in paper space. You can still control the

dash lengths with LTSCALE

When you change PSLTSCALE or use a command such as ZOOM with

PSLTSCALE set to 1, objects in viewports are not automatically regenerated

with the new linetype scale. Use the REGEN or REGENALL command to update

the linetype scales in each viewport.

PSTYLEMODE

Quick Reference