2012

Dimensional Panel
Linear (BCPARAMETER) Creates a horizontal or vertical constraint parameter
based on the locations of the extension line origins and the location of the
dimension line similar to the DIMLINEAR command.
Horizontal (BCPARAMETER) Creates a horizontal constraint parameter by
picking two constraint points. Valid objects include lines and polyline
segments.
Vertical (BCPARAMETER) Creates a vertical constraint parameter by picking
two constraint points. Valid objects include lines and polyline segments.
Aligned (BCPARAMETER) Creates an aligned constraint parameter using one
of the following ways.
■ Selects a point and a line object. The aligned constraint controls the
distance between a point and the closest point on a line.
■ Selects two line objects. The lines are made parallel and the aligned
constraint controls the distance between the two lines.
Radius (BCPARAMETER) Creates a radial constraint parameter for a circle,
arc, or polyline arc segment.
Diameter (BCPARAMETER) Creates a diameter constraint parameter for a
circle, arc, or polyline arc segment.
Angular (BCPARAMETER) Creates an angular constraint parameter by picking
two lines or polyline segments or an arc. It is similar to an angular dimension.
Convert (BCPARAMETER) Converts the dimensional constraints to constraint
parameters.
Block Table Displays a dialog box to define variations of a block.
Constraint Settings Sets preferences in behavior when displaying dimensional
constraints.
Manage Panel
Delete Constraints Removes all geometric and dimensional constraints from
a selection set of objects.
Construction Geometry Converts geometry into construction geometry.
Block Constraint Status Turns the constraint display status on and off and
controls the shading of objects based on their constraint level.
124 | Chapter 3 B Commands