2012

Geometric Panel
Auto Constrain Applies geometric constraints to a selection set of objects
based on orientation of the objects relative to one another.
Coincident (GEOMCONSTRAINT) Constrains two points together or a point
to a curve (or an extension of a curve).
Colinear (GEOMCONSTRAINT) Causes two or more line segments to lie
along the same line.
Concentric (GEOMCONSTRAINT) Constrains two arcs, circles, or ellipses to
the same center point.
Fix (GEOMCONSTRAINT) Locks points and curves in position.
Parallel (GEOMCONSTRAINT) Causes selected lines to lie parallel to each
other.
Perpendicular (GEOMCONSTRAINT) Causes selected lines to lie 90 degrees
to one another.
Horizontal (GEOMCONSTRAINT) Causes lines or pairs of points to lie parallel
to the X axis of the current coordinate system.
Vertical (GEOMCONSTRAINT) Causes lines or pairs of points to lie parallel
to the Y axis of the current coordinate system.
Tangent (GEOMCONSTRAINT) Constrains two curves to maintain a point
of tangency to each other or their extensions.
Smooth (GEOMCONSTRAINT) Constrains a spline to be contiguous and
maintain G2 continuity with another spline, line, arc, or polyline.
Symmetric (GEOMCONSTRAINT) Causes selected objects to become
symmetrically constrained about a selected line.
Equal (GEOMCONSTRAINT) Resizes selected arcs and circles to the same
radius, or selected lines to the same length.
Show Constraints Displays constraint bars for the selected objects with
geometric constraints applied to them.
Show All Displays all geometric constraints in the drawing.
Hide All Hides all geometric constraints in the current drawing.
Constraint Settings Controls the display of geometric constraints on constraint
bars.
Block Editor Ribbon Contextual Tab | 123