2012

A larger number results in more graphical vectors being displayed as objects
are dragged. For best performance, it is recommended that you use hardware
acceleration rather than software acceleration. DRAGP2 has no effect when
dragging objects in a 3D viewport.
DRAWORDERCTL
Quick Reference
See also:
■ Control How Overlapping Objects Are Displayed
IntegerType:
DrawingSaved in:
3Initial value:
Controls the default display behavior of overlapping objects when they are
created or edited.
Turns off the default draw order of overlapping objects:
after objects are edited, regardless of their draw order,
0
the objects are displayed on top until a drawing is regen-
erated (REGEN) or reopened. This setting also turns off
draw order inheritance: new objects that are created from
another object using the commands listed below are not
assigned the draw order of the original object. Use this
setting to improve the speed of editing operations in large
drawings. The commands that are affected by inheritance
are BREAK, FILLET, HATCH, HATCHEDIT, EXPLODE, TRIM,
JOIN, PEDIT, and OFFSET.
Turns on the default draw order of objects: after objects
are edited, they are automatically displayed according to
the correct draw order.
1
Turns on draw order inheritance: new objects created
from another object using the commands listed above are
assigned the draw order of the original object.
2
Provides full draw order display. Turns on the correct draw
order of objects, and turns on draw order inheritance.
3
1484 | Chapter 31 D System Variables