2012

Specify Action Location Specify Action Location on page 99
■
Multiplier on page 100
■
Offset on page 100
BASE
Quick Reference
See also:
■ Insert Blocks
Sets the insertion base point for the current drawing.
Access Methods
Button
Ribbon: Insert tab ➤ Block panel ➤ Set Base Point
Menu: Draw ➤ Block ➤ Base
Command entry: base (or 'base for transparent use)
Summary
The base point is expressed as coordinates in the current UCS. When you
insert or externally reference the current drawing into other drawings, this
base point is used as the insertion base point.
BASSOCIATE
Quick Reference
See also:
■ Modify Dynamic Block Definitions
104 | Chapter 3 B Commands