2012

You can specify an object snap with any of the following methods:
■ Enter a object snap by typing its name. To see a list of valid object snaps,
refer to the
OSNAP on page 893 command or the Drafting Settings Dialog
Box
on page 414.
■ Click an object snap from the Object Snap toolbar.
■ Click an object snap from the Object Snap shortcut menu. You can diisplay
this shortcut menu by pressing SHIFT while you right-click.
Use Running Object Snaps
Using the OSNAP or DSETTINGS commands, you can specify a set of running
object snaps. Running object snaps are one or more object snaps that remain
in effect as you work.
■ To turn running object snaps on and off, click the OSNAP button on the
status bar or press F3.
■ Press TAB to cycle through the object snap possibilities before you specify
the point.
■ To turn off running object snaps for the next point only, specify the None
object snap.
Selection Modes (Command Modifier)
Quick Reference
See also:
■ Select Objects
Controls how you create selection sets
Command entry: At a prompt to select objects, enter one of the valid selection
modes described in the SELECT command
The selection mode you enter remains active only for the current Select Objects
prompt.
Selection Modes (Command Modifier) | 1373