2012

Sets the Y coordinate value.
Z
Sets the Z coordinate value.
Path Type
Select the full (absolute) path, the relative path to the external reference file,
or No Path, the name of the external reference (the file must be located in the
same folder as the current drawing file).
Rotation
Specify on-screen
If Specify On-Screen is selected, you may wait until you exit the dialog box
to rotate the object with your pointing device or at the Command prompt.
Angle
If Specify On-Screen is cleared, enter the rotation angle value in the dialog
box.
Block Unit
Displays information about the block units.
Block Name Displays the name of the block associated with the selected
external reference.
Unit Displays the specified INSUNITS value for the inserted block.
Factor Displays the unit scale factor, which is calculated based on the
INSUNITS value of the block and the drawing units.
Show Details
Displays the external reference file paths.
Found In Displays the path where the external reference file is located.
Saved Path Displays the path that is saved with the drawing when the external
reference is attached. The path is dependent upon the Path Type setting.
1346 | Chapter 24 X Commands