2012

List of Prompts
The following prompts are displayed.
Specify
insertion point on page 1336 or [Scale on page 1336/X on page 1336/Y on
page 1336/
Z on page 1336/Rotate on page 1336/PScale on page 1337/PX on page 1337/PY
on page 1337/PZ on page 1337/PRotate on page 1337]: Specify a point or enter an option
Insertion Point
Places a copy of the metafile with its base point at the specified insertion
point.
X Scale Factor Sets the X and Y scale factors.
All X and Y dimensions of the metafile are multiplied by the X and Y scale
factors supplied. The metafile is rotated by the angle specified, using the
insertion point as the center of rotation.
Corner Defines the X and Y scales at the same time, using the insertion point
and another point as the corners of a box. The X and Y dimensions of the box
become the X and Y scale factors. The insertion point is the first corner.
The rotation angle sets the angle of the WMF file.
XYZ Scales the metafile in all three dimensions.
If you enter c, you specify a corner point. The specified point and the insertion
point determine the X and Y scale factors for the WMF file.
The rotation angle sets the angle of the WMF file.
Scale
Sets the scale factor for the X, Y, and Z axes. The scale for the Z axis is the
absolute value of the specified scale factor.
X
Sets the X scale factor.
Y
Sets the Y scale factor.
Z
Sets the Z scale factor.
Rotate
Sets the angle of insertion for the WMF file.
■
X Scale Factor on page 1336
■ Corner on page 1336
■ XYZ on page 1336
1336 | Chapter 23 W Commands