2012

Select the objects that define the cutting edges to which you want to trim an
object, or press Enter to select all displayed objects as potential cutting edges.
TRIM projects the cutting edges and the objects to be trimmed onto the XY
plane of the current user coordinate system (UCS).
NOTE To select cutting edges that include blocks, you can use only the single
selection, Crossing, Fence, and Select All options.
Select object to trim on page 1261 or shift-select to extend on page 1261 or [Fence
on page 1261/Crossing on page 1261/Project on page 1261/Edge on page 1262/eRase
on page 1263/Undo on page 1263]: Select an object to trim, hold down SHIFT and
select an object to extend it instead, or enter an option
Specify an object selection method to select the objects to trim. If more than
one trim result is possible, the location of the first selection point determines
the result.
Object to Trim
Specifies the object to trim.
Shift-Select to Extend
Extends the selected objects rather than trimming them. This option provides
an easy method to switch between trimming and extending.
Fence
Selects all objects that cross the selection fence. The selection fence is a series
of temporary line segments that you specify with two or more fence points.
The selection fence does not form a closed loop.
Crossing
Selects objects within and crossing a rectangular area defined by two points.
NOTE Some crossing selections of objects to be trimmed are ambiguous. TRIM
resolves the selection by following along the rectangular crossing window in a
clockwise direction from the first point to the first object encountered.
Project
Specifies the projection method used when trimming objects.
TRIM | 1261