2012

RMS Error
Reports the RMS (root mean square) error, which measures how close the
program has come to finding a perfect fit. The goal is the smallest RMS error.
Standard Deviation
Reports the standard deviation of the residuals. If it is near zero, the residual
at each calibration point is about the same.
Largest Residual/At Point
Reports the point at which the mapping is least accurate. The residual is the
distance between where the point was mapped during transformation and
where it would be mapped if the fit were perfect. The distance is given in the
current linear units.
Second-Largest Residual/At Point
Reports the point at which the mapping is second-least accurate. The residual
is the distance between where the point was mapped during transformation
and where it would be mapped if the fit were perfect. The distance is given in
the current linear units.
Cfg
Designates or realigns the tablet menu areas or designates a small portion of
a large tablet as a screen pointing area.
If tablet menus are in use and the same number of menus is selected, the
following prompts are displayed:
Do you want to realign tablet menus? [Yes/No] <N>: Enter y or n or press Enter
Digitize upper-left corner of menu area n: Digitize a point (1)
Digitize lower-left corner of menu area n: Digitize a point (2)
Digitize lower-right corner of menu area n: Digitize a point (3)
In the prompt, n is the menu number (1-4).
The printed menu form must be affixed to the tablet surface, and the requested
points must be digitized. The set of three points must form a 90-degree angle.
Tablet menu areas can be skewed at any angle.
TABLET | 1227